These systems are operated by remote control, or by a simple key switch arrangement. The roller is powered by a single or three phase electrical supply which can also be transformed to low voltage depending on the position of the system.
The roller is manufactured in stainless steel, tube diameter ranging between 200mm - 400mm, to suit width of pool. Brackets can be manufactured in stainless or hot-dipped galvanised steel. Wall and ceiling mounted systems are supported by end brackets enclosed in GRP covers, and fixed to a load bearing wall or ceiling
Column mount systems are free-standing and bolted to the floor, covered by GRP protective moulding. Alternatively, systems can be fixed to a suitable wall using columns for additional support.
Manual pool cover systems can be either fixed or mobile, these systems are manufactured from stainless steel with white powder coated supporting frames, mobile systems are mounted on stainless steel braked castors for easy mobility.
Single or twin covers can be fitted to one system using quick release straps and buckles, manual systems are available to a maximum width of 7m, systems can be fitted with a 5:1 reduction gearbox for pools over 100m2 or to any system if requested.
Customised Storage Systems
At Forge Leisure we understand that standard designed storage systems may not be practical for some sites, however we have the knowledge and experience to design and manufacture system specific for your requirements. Please contact us for helpful technical advice.